Gas chromatography/mass spectrometry of polychlorinated biphenyls using atmospheric pressure chemical ionization and atmospheric pressure photoionization microchips

Gas chromatography (GC) and ion trap mass spectrometry (MS) were combined with microchip atmospheric pressure chemical ionization (microAPCI) and microchip atmospheric pressure photoionization (microAPPI) sources. Selected polychlorinated biphenyls (PCBs, IUPAC Nos. 28, 52, 101, 118, 138, 153 and 180) were analyzed by GC/microAPCI-MS and GC/microAPPI-MS to demonstrate the applicability of the miniaturized ion sources in negative ion mode analysis. The microAPCI and microAPPI methods were evaluated in respect of detection limit, linearity and repeatability. The detection limits for the PCB congeners were somewhat lower with microAPCI than with microAPPI, whereas microAPPI showed slightly wider linear range and better repeatability. With both methods, the best results were obtained for highly chlorinated or non-ortho-chlorinated PCBs, which possess the highest electron affinities. Finally, the suitability of the GC/microAPPI-MS method for the analysis of PCBs in environmental samples was demonstrated by analyzing soil extracts, and by comparing the results with those obtained by gas chromatography with electron capture detection (GC/ECD).     

Silicon micropillar array electrospray chip for drug and biomolecule analysis

We have developed a lidless micropillar array electrospray ionization chip (microPESI) combined with mass spectrometry (MS) for analysis of drugs and biomolecules. The microPESI chip, made of silicon, contains a sample introduction spot for a liquid sample, an array of micropillars (diameter, height, and distance between pillars in the range of 15-200, 20-40, and 2-80 microm, respectively), and a sharpened tip for direct electrospray formation. The microchips were fabricated using deep reactive ion etching (DRIE) which results in accurate dimensional control. The chip, providing a reliable open-channel filling structure based on capillary forces and a electrospray emitter tip for ionization, allows an easy operation and reliable, non-clogging liquid transfer. The microPESI chip can be used for a fast analysis using single sampling or for continuous infusion measurements using a syringe pump for sample introduction. The microPESI-MS shows high sensitivity, with limit of detection 30 pmol/L (60 amol or 28 fg) for verapamil measured with tandem mass spectrometry (MS/MS) and using a sample volume of 2.5 microL. The system shows also good quantitative linearity (r2 > 0.99) with linear dynamic range of at least six orders of magnitude and good ion current stability (standard deviation <5%) in 1-h continuous flow measurement. The microPESI-MS is shown to be a very potential method for direct analysis of drugs and biomolecules.     

Analytical characterization of microfabricated SU-8 emitters for electrospray ionization mass spectrometry

We present a detailed optimization and characterization of the analytical performance of SU-8-based emitters for electrospray ionization mass spectrometry (ESI/MS). The improved SU-8 fabrication process presented here enhances patterning accuracy and reduces the time and cost of fabrication. All emitters are freestanding and enable sample delivery by both pressure-driven and spontaneous flows. The optimized emitter design incorporates a sharp, double-cantilevered tip implemented to the outlet of an SU-8 microchannel and provides highly sensitive ESI/MS detection. Moreover, the optimized design allows the use of relatively large microchannel dimensions (up to 200 x 50 microm(2), w x h) without sacrificing the detection sensitivity. This is advantageous with a view of preventing emitter clogging and enabling reproducible analysis. The measured limits of detection for the optimized emitter design were 1 nM for verapamil and 4 nM for Glu-fibrinopeptide B with good quantitative linearities between 1 nM and 10 microM (R(2) = 0.9998) for verapamil and between 4 nM and 3 microM (R(2) = 0.9992) for Glu-fibrinopeptide B. The measured tip-to-tip repeatability for signal intensity was 14% relative standard deviation (RSD) (n = 3; 5 microM verapamil) and run-to-run repeatability 4-11% RSD (n = 4; 5 microM verapamil) for all individual emitters tested. In addition, long-term stability of < 2% RSD was maintained for timescales of 30 min even under free flow conditions. SU-8 polymer was also shown to be chemically stable against most of the tested electrospray solvents.     

Carbohydrate and steroid analysis by desorption electrospray ionization mass spectrometry

Desorption electrospray ionization mass spectrometry (DESI-MS) is applied to the analysis of carbohydrates and steroids; the detection limits are significantly improved by the addition of low concentrations of salts to the spray solvent.     

Vibrational characterization of the 1:1 iodine-benzene complex isolated in solid krypton

The structure and properties of a 1:1 iodine-benzene complex isolated in an inert krypton matrix at low temperature have been studied with infrared and resonance Raman spectroscopy and with MP2 calculations. The structure of the ground-state complex is found to be unsymmetric, and the I-I vibrational frequency is found to be red-shifted by 3.94 cm(-1) upon complexation. The experimental data agree well with computational results, leading to the conclusion that the I2-Bz complex structure is not axial but of above-bond type, identically with other halogen-benzene complexes.     

Ionspray microchip

An ionspray microchip is introduced. The chip is based on the earlier presented nebulizer microchip that consists of glass and silicon plates bonded together. A liquid inlet channel, nebulizer gas inlet, and nozzle are etched on the silicon plate and a platinum heater is integrated on the glass plate. The nebulizer microchip has been previously used in atmospheric pressure chemical ionization, atmospheric pressure photoionization, sonic spray ionization, and thermospray ionization modes. In this work we show that the microchip can be operated also in ionspray mode by introducing high voltage to the silicon plate of the microchip. The effects of operation parameters (voltage, nebulizer gas pressure, sample solution flow rate, solvent composition, and analyte concentration) on the performance of the ion spray microchip were studied. Under optimized conditions the microchip provides efficient ionization of small and large compounds and good quantitative performance. The feasibility of the ion spray microchip in liquid chromatography/mass spectrometry (LC/MS) was demonstrated by the analysis of tryptic peptides of bovine serum albumin. Copyright © 2010 John Wiley & Sons, Ltd.     

Characterizing a UV chamber with mercury lamps for assessment of comparability to natural UV conditions

UV radiation conditions in a UV chamber equipped with four 300-W mercury vapour lamps have been characterized to assess the exposure received by the specimens aged in the chamber. Spectrally resolved measurements were performed on UV radiation emitted by new lamps and lamps operated for 4850 h in the chamber. An intensity decrease of as much as 75% with a strong wavelength dependency was detected. By linking the measurements with independent broadband measurements of the UV radiation field emitted by a single lamp, the UV dose rate distribution on the specimen plane of the chamber was derived. A method for true exposure accumulation estimation, accounting for the fading of the lamps, was developed. Accumulated UV radiation exposures on material samples in the chamber were derived and compared to long-term (1995–2007) average UV exposures received in natural sunshine at Jokioinen, Finland (lat. 60.4°N, long. 23.5°E, 104 m a.s.l.). Acceleration factors for the exposure in the UV chamber were derived in terms of doses integrated over different wavelength ranges. The acceleration factor was found to depend strongly on the wavelength range of the dose considered, presenting an extra challenge to the assessment of the artificial material exposure duration.     

Analysis of lipids with desorption atmospheric pressure photoionization‐mass spectrometry (DAPPI‐MS) and desorption electrospray ionization‐mass spectrometry (DESI‐MS)

In this article, the effect of spray solvent on the analysis of selected lipids including fatty acids, fat‐soluble vitamins, triacylglycerols, steroids, phospholipids, and sphingolipids has been studied by two different ambient mass spectrometry (MS) methods, desorption electrospray ionization‐MS (DESI‐MS) and desorption atmospheric pressure photoionization‐MS (DAPPI‐MS). The ionization of the lipids with DESI and DAPPI was strongly dependent on the spray solvent. In most cases, the lipids were detected as protonated or deprotonated molecules; however, other ions were also formed, such as adduct ions (in DESI), [M‐H]⁺ ions (in DESI and DAPPI), radical ions (in DAPPI), and abundant oxidation products (in DESI and DAPPI). DAPPI provided efficient desorption and ionization for neutral and less polar as well as for ionic lipids but caused extensive fragmentation for larger and more labile compounds because of a thermal desorption process. DESI was more suitable for the analysis of the large and labile lipids, but the ionization efficiency for less polar lipids was poor. Both methods were successfully applied to the direct analysis of lipids from pharmaceutical and food products. Although DESI and DAPPI provide efficient analysis of lipids, the multiple and largely unpredictable ionization reactions may set challenges for routine lipid analysis with these methods. Copyright © 2012 John Wiley & Sons, Ltd.     

Rapid LC-UV Analysis of Iohexol in Canine Plasma for Glomerular Filtration Rate Determination

A rapid high-performance liquid chromatography UV method and a simple sample preparation for analyzing iohexol in canine plasma, for evaluating glomerular filtration rate (GFR) and intestinal permeability, were developed and validated. Trifluoroacetic acid (TFA) was used for protein precipitation and iohexol extraction from plasma, followed by vortex mixing and centrifugation. As an internal standard, 4-aminobenzoic acid (para-aminobenzoic acid, PABA) was added. The supernatant (5 μL) was injected into a Zorbax SB-C18 LC column maintained at 50 °C. The mobile phase of the LC method was a water–methanol gradient at pH 3.0 adjusted with TFA. Fast LC measurement was achieved by using a rapid-resolution LC technique. Total run time was 13 min, and UV wavelength was set at 246 nm. Precision of the method was 0.2–9.0%, depending on the iohexol concentration in plasma. Recovery of iohexol from plasma was over 90%, and recovery of the internal standard 99.1 ± 1.4%. The calibration curve was linear (r = 0.9997) over iohexol concentrations of 2.5–150 μg mL^?1 (n = 5). This method is fast, simple, reliable and applicable in clinical settings.